Product type of deburring machine

Mechanical law

With the help of an industrial manipulator, the rotating wire brush or grinding wheel is clamped, and the burr is polished by the joint arm movement of the manipulator to remove the burr. The manipulator can select wire brushes or grinding wheels from the shelf in the tool library to meet the needs of removing burrs on different parts of the parts. However, this method is often not suitable for use in many occasions because the arm joints of the manipulator lack sufficient rigidity and precision. Moreover, due to the different structure of the parts, some parts cannot be deburred by this method, and other deburring equipment has to be equipped.

Vibration method

This is designed for the deburring of smaller rotating parts or diamond-shaped parts. The parts are placed in a large container filled with granular ceramic media. The size of the media varies according to the type, size and material of the burr part. The rapid reciprocating vibration of the container makes the parts of the parts move and rub against the ceramic medium to remove burrs and polish the surface of the parts. The strength of the vibration can be adjusted to suit parts of different sizes.

Thermal method

The process of thermal deburring is a process of oxidizing into powder at high temperature. The thermal deburring machine seals the parts with burrs in a container filled with high-pressure combustible gas and oxygen. The burrs on the parts, whether on the outside, inside, or blind holes, are surrounded by this mixed gas. After the spark plug ignites the mixed gas, it generates an instantaneous high temperature heat wave. Because the ratio of the surface area of the burr part to the gas is quite high, the burr burns, and the burr continues to oxidize and transform within a cycle time of 15 to 30 seconds. Turn into powder, and then clean the workpiece with solvent.

This method is the only method that can uniformly remove burrs. It can remove all unnecessary materials from the surface of all parts, and even remove burrs from hard-to-reach internal grooves and intersecting holes, and afterwards No need to check. Therefore, it is widely used in the deburring process of ferrous and non-ferrous metal parts.

Electrochemical method

The electrochemical (also known as electrolysis) deburring machine dissolves metal materials from the parts into the electrolyte through electrochemical reactions, thereby removing the burrs on the parts. The tool electrode is connected to the negative pole of the DC power supply, and the burr parts are connected to the positive pole of the power supply. The electrolyte is passed through at a certain pressure and flow rate, and then the DC power supply is connected. In this way, the metal as the anode will gradually undergo electrochemical dissolution to achieve removal The purpose of the burr (or molding).