Working principle of deburring machine

Removal of burrs on the billet has two functions: to improve the quality of billet rolling; and to reduce the damage to the transfer roller and the roller. After the slab is formed in the continuous casting machine, it is cut to a fixed length, and then transferred to the dehairing machine by the driving roller.

working principle 

The cutting process into the deburring village. The initial state of the deburring machine The plunger beam of the deburring machine is in the low position, the blade is retracted, and the upper edge of the blade is located below the upper edge of the Korean road. When the blank is transported to the grating LB1, the traveling speed of the blank is reduced from the conveying speed Vt to the deburring speed Ve, and it runs at the speed of Ve to the grating LB3, and the conveying of the blank is stopped. The blade and the plunger beam rise at the same time, and the blade presses on the lower surface of the billet. The billet moves to the right at a speed of Ve to complete the hair removal action; when the billet moves to the grating LB2, the blade and the plunger beam descend at the same time, the billet transmission stops, and at the same time The plunger beam is turned 90° to complete the cleaning process. Then the billet moves to the left at the conveying speed Vt, and enters the procedure of removing the burrs at the tail of the billet, and the process of removing the burrs is the same as above.